Fig. Engine
1. Dipstick
2. Filler plug
Fig. Hydraulic reservoir
1. Sight glass
2. Filler hose
2019-09-23
Maintenance, 10h
Every 10 hours of operation (Daily)
Engine - Checking the oil level
2
Open the engine cover lock and lower the engine
1
cover forwards.
Check the oil level using the dipstick (1). The level
should be between the marks. If the level is near the
lower mark, top off with fresh engine oil via the filler
cap (2). See under the heading lubricants for the
correct oil grade.
Hydraulic reservoir, Level check - Filling
Wipe the sight glass (1) clean. Make sure that the oil
2
level is in the middle of the sight glass. If necessary,
top up with fresh hydraulic fluid through the filler hose
(2).
See under the heading 'Lubricants' for the correct fluid
grade.
1
4812163901_A.pdf
Park the roller on a level surface.
Park the roller on a level surface.
The engine must be switched off and the
The engine must be switched off and the
parking brake activated when checking or
parking brake activated when checking or
adjusting the roller, unless otherwise specified.
adjusting the roller, unless otherwise specified.
Ensure that the engine cover is fully open when
Ensure that the engine cover is fully open when
work is carried out under the cover.
work is carried out under the cover.
Never overfill with oil, as this can
Never overfill with oil, as this can
damage the engine.
damage the engine.
Maintenance, 10h
61