Technical Specifications; Vibrations - Operator Station; Noise Level; Slopes - Fayat Group Dynapac CC900G Instruction Manual

The vibration levels are measured in accordance with the operational cycle described in The vibration levels are measured in accordance with the operational cycle described in
EU directive 2000/14/EC on machines equipped for the EU market, with vibration switched EU directive 2000/14/EC on machines equipped for the EU market, with vibration switched
on, on soft polymer material and with the operator's seat in the transport position. on, on soft polymer material and with the operator's seat in the transport position.
Measured whole-body vibrations are below the action value of 0.5 m/s² as specified in Directive Measured whole-body vibrations are below the action value of 0.5 m/s² as specified in Directive
2002/44/EC. (Limit is 1.15 m/s²) 2002/44/EC. (Limit is 1.15 m/s²)
Measured hand/arm vibrations also were below the action level of 2.5 m/s² specified in the same Measured hand/arm vibrations also were below the action level of 2.5 m/s² specified in the same
directive. (Limit is 5 m/s²) directive. (Limit is 5 m/s²)
The noise level is measured in accordance with the operational cycle described in EU The noise level is measured in accordance with the operational cycle described in EU
directive 2000/14/EC on machines equipped for the EU market, on soft polymer material directive 2000/14/EC on machines equipped for the EU market, on soft polymer material
with vibration switched on and the operator's seat in the transport position. with vibration switched on and the operator's seat in the transport position.
Guaranteed sound power level, L Guaranteed sound power level, L
Sound pressure level at the operator's ear (platform), L Sound pressure level at the operator's ear (platform), L
During operation the above values may differ because of the actual operational During operation the above values may differ because of the actual operational
conditions. conditions.
Max 20° or 36% Max 20° or 36%
2019-09-23

Technical specifications

Vibrations - Operator station

(ISO 2631)

Noise level

wA wA

Slopes

This angle has been measured on a hard, flat surface
with the machine stationary.
The steering angle was zero, the vibration was
switched OFF and all tanks were full.
Always take into consideration that loose ground,
steering the machine, vibration on, machine speed
across the ground and raising the center of gravity can
all cause the machine to topple at smaller slope
angles than those specified here.
4812163901_A.pdf
Technical specifications
pA pA
102 dB (A) 102 dB (A)
84 ±3 dB (A) 84 ±3 dB (A)
13