2019-09-23
Special instructions
Standard lubricants and other recommended
oils and fluids
Before leaving the factory, the systems and
components are filled with the oils and fluids specified
in the lubricant specification. These are suitable for
ambient temperatures in the range -15°C to +40°C
(5°F - 105°F).
The maximum ambient temperature for
The maximum ambient temperature for
biological hydraulic fluid is +35°C (95°F).
biological hydraulic fluid is +35°C (95°F).
Higher ambient temperatures, above +40°C
(104°F)
For operation of the machine at higher ambient
temperatures, although maximum +50°C (122°F), the
following recommendations apply:
The gasoline engine can be run at this temperature
using normal oil. However, the following fluids must be
used for other components:
Hydraulic system - mineral oil Shell Tellus T100 or
equivalent.
Lower ambient temperature - Freeze risk
Make sure that the watering system is empty/drained
of water (sprinkler, hoses, tank/s) or that anti-freeze
has been added, to prevent the system freezing.
Temperatures
The temperature limits apply to standard versions of
rollers.
High pressure cleaning
Do not spray water directly onto electrical components
or the instrument panels.
Place a plastic bag over the fuel filler cap and secure
with a rubber band. This is to avoid high pressure
water entering the vent hole in the filler cap. This could
cause malfunctions, such as the blocking of filters.
Do not spray with high-pressure cleaner directly onto
gaskets and bearing spacings in steering hitch and
drum, and electronics.
Never aim the water jet directly at the fuel tank
Never aim the water jet directly at the fuel tank
cap, or into exhaust pipe. This is particularly
cap, or into exhaust pipe. This is particularly
important when using a high-pressure cleaner.
important when using a high-pressure cleaner.
4812163901_A.pdf
Special instructions
9