Rear Panel - Native Instruments TRAKTOR AUDIO 10 Manual

• (2) MIDI: The MIDI section in the middle of the panel consists of a MIDI IN and a MIDI
OUT socket acting as an interface for MIDI devices (synths, controllers, etc.) typically
interacting with software on your computer or controlling external MIDI equipment.
• (3) Headphones:
• The headphones section has a 1/4" stereo socket for connecting headphones with
a 1/4" stereo jack.
•
The VOLUME knob in this section controls the output signal to the headphones.
•
The SOURCE button switches between monitoring the incoming signal on the MAIN IN
(direct monitoring) and the outgoing signal at the MAIN OUT.

5.2 Rear Panel

5.2 The rear panel of the TRAKTOR AUDIO 10.
• (1) Grounding Post (GND): The grounding post at the upper left is where the ground wire
for all turntables can be affixed. Grounding your turntable is essential in eliminating
mostly the low frequency buzzing noises and some pops and hisses.
• (2) USB Port: The USB port connector connects the TRAKTOR AUDIO 10 soundcard to
your computer or workstation via USB 2.0 and exchanges data with your computer. The
TRAKTOR AUDIO 10, however, is not solely USB-powered; the DC power supply needs
to be plugged in at all times.
• (3) DC Adapter Socket: The 9 volt DC power supply attaches to this socket. The TRAKTOR
AUDIO 10 relies on additional power than what the USB cable provides, and the power
supply needs to be plugged in at all times.
24 – TRAKTOR AUDIO 10 – Manual