Installation; System Requirements; Software Installation; Installing Traktor Audio 10 On Windows® 7 - Native Instruments TRAKTOR AUDIO 10 Manual

3

Installation

In order for the TRAKTOR AUDIO 10 to work properly with your computer, the following
two programs are automatically installed on your system during the software installation
process:
• The TRAKTOR AUDIO 10 driver. This handles the communication between the audio
interface and your computer.
• The Control Panel software:
•
In Windows®, the Control Panel software allows you to adjust performance set-
tings, preamp settings, to perform diagnostics, and to configure the soundcard's
port settings.
•
In Mac OS® X, the performance settings and preamp settings are controlled from
the system's Audio MIDI setup, located in the Utilities folder. The port configuration
again is accessed through the Control Panel software.
If you are familiar with the installation procedure and the general configuration of USB-
% !
driven audio devices on your computer, you can skip this chapter and continue with
registration chapter 10.

3.1 System Requirements

For the latest system requirements of your product, please visit the product page at http://
www.native-instruments.com/TA10.

3.2 Software Installation

3.2.1 Installing TRAKTOR AUDIO 10 on Windows® 7
! !
Do not connect the TA10 to your computer before the software installation process is
finished.
To install the TRAKTOR AUDIO 10 on Windows® 7:
1. Place the installation disc in your computer's CD/DVD-ROM drive.
2. Use Windows® Explorer to browse the contents of the disc.
3. Double-click the installer file: "TRAKTOR AUDIO 10 Setup PC.exe."
TRAKTOR AUDIO 10 – Manual – 9