Native Instruments TRAKTOR AUDIO 10 Manual page 49

To use your TRAKTOR AUDIO 10 in a digital DJing setup with a DJing software and internal mixing:
1.
Plug the 1/4" TRS jack of your headphones into the PHONES socket on the TA10's
front panel. Turn the Headphone Volume Control knob (VOLUME) to the left-end stop
to set the volume to minimum.
2. Set the volume on your active speakers / stereo amplifier to minimum.
3. Connect the OUT channel of a selected port on the rear panel of the TA10 (the port
your DJ software outputs audio through) to your active speakers / stereo amplifier. Use
a stereo RCA (phono) cable. In case your active speakers have 1/4" or XLR sockets,
use RCA adapter cables to connect them to the TA10.
4. Start the playback of a track in your DJing software.
5. Gradually raise the volume on your active speakers / stereo amplifier until you reach a
good listening level.
! !
For information on how to configure your DJ software, please refer to your software's
documentation.
48 – TRAKTOR AUDIO 10 – Manual