Connecting A Dynamic Microphone For Recording - Native Instruments TRAKTOR AUDIO 10 Manual

2. With the SOURCE button next to the PHONES socket, set the headphone monitoring
source to OUT 1/2 for monitoring the output signal of your computer.
3. Start the playback of an audio file on your computer.
4. Gradually turn the Headphone Volume Control knob (VOLUME) of the TA10 to the right
until you reach a good listening level.
7.3.2 Connecting a Dynamic Microphone for Recording
7.8 TRAKTOR AUDIO 10 in a recording setup with a dynamic microphone and headphones.
! !
Make sure the TRAKTOR AUDIO 10 software is installed correctly, the interface is
connected to your computer, and the power supply is plugged in as described in chapter
3. Also make sure to have the soundcard set up as your computer's main audio output
device (chapter 4) before you proceed.
64 – TRAKTOR AUDIO 10 – Manual