Channel Setup (Port Configuration On Windows®) - Native Instruments TRAKTOR AUDIO 10 Manual

6.1.2 Channel Setup (Port Configuration on Windows®)
The
Channel Setup page allows you to configure the port settings (ports A through D) of your
TRAKTOR AUDIO 10. This area determines whether a port is set to amplify Phono
nal and if the incoming signal should bypass internal processing by your computer (Direct
and be sent to the output channels immediately or not. You can furthermore choose between
configuring a temporary (Current) and a default setting (Startup) for each port.
By default, the soundcard is set to Phono
% !
for mixing analog signal from turntables, and Line
D for mixing analog signal from CD decks.
6.4 The Control Panel on Windows®
Port Options
The port configuration area of each port (A-D) contains two control sections: Input Routing
and Input Sens:
•
Input Routing:
•
Tick the Direct
cessing by your computer. This function is intended for analog mixing where you may
want the incoming signal (e.g., when mixing in records from a turntable) to be sent
directly from the port's input to the port's output channels. Note: When using the
soundcard for analog mixing in
has to be activated. See the Temporary and Default Settings subsection below for
instructions on how to configure the soundcard's behavior on initial start up.
•
Deactivate the
timecode CDs). The signal has to be sent through your computer for the timecode
data to be processed by your DJ software.
Thru checkbox if you want the incoming signal to bypass internal pro-
stand-alone mode (without a computer), Direct Thru
Direct Thru option for digital mixing (when using timecode vinyl or
with activated Direct Thru
with activated Thru mode
TRAKTOR AUDIO 10 – Manual – 31
or Line sig-
Thru)
mode on ports A and B
on ports C an