Native Instruments TRAKTOR AUDIO 10 Manual page 67

3. Plug the 1/4" jack of your dynamic microphone into the MIC input on the front panel of the TA10.
4. While singing / talking into the microphone, adjust the input signal by turning the GAIN
knob gradually to the right. Check the input LED (MAIN IN LED on the top panel of the
soundcard) to make sure your input signal does not clip; adjust the input level so that
the LED lights green on input. A red lighting LED indicates signal clipping (the signal
is too loud).
5. Gradually turn the Volume Control knob (VOLUME) in the headphone section of the
TA10 to the right until you reach a good listening level.
You can also use the MAIN OUT 1/2 channel on the front panel to send the input from
% !
the microphone to a separate mixer channel or another output device, e.g., for using the
microphone in a DJing context.
! !
For information on how to adjust the audio input for recording in your audio recording
software, please refer to your software's documentation.
66 – TRAKTOR AUDIO 10 – Manual