Native Instruments TRAKTOR AUDIO 10 Manual page 66

To use your TRAKTOR AUDIO 10 in a recording setup with a dynamic microphone and
headphones:
1. Plug the 1/4" TRS jack of your headphones into the PHONES socket on the TA10's
front panel. Turn the Headphone Volume Control knob (VOLUME) to the left-end stop
to set the volume to minimum.
2. With the SOURCE button next to the PHONES socket, set the headphone monitoring
source to OUT 1/2 for monitoring the output signal of your computer. If you want to
monitor the microphone input signal at zero latency, you can set the SOURCE to IN 1/2.
TRAKTOR AUDIO 10 – Manual – 65