Registration - Native Instruments TRAKTOR AUDIO 10 Manual

XP Users Only: Completing the Device Driver Installation
Upon detection of the new hardware, Windows® completes the device driver installation:
1. Windows® XP will identify the TRAKTOR AUDIO 10 soundcard. Choose No
dows® asks you to search the internet for a driver.
2. During device driver installation, a Windows® message may call attention to the fact
that the TRAKTOR AUDIO 10 driver has not passed Windows® Logo Testing. This is an
expected behavior and does not indicate a problem. To proceed, click Continue
→
Your computer will display a "New Hardware
sage reading
was completed successfully.
▶
After you have completed the driver installation procedure, the driver installer will
start again. This is intended behavior. Repeat the previous steps in order to install all
required driver components.
→ All software components are now installed, and the TRAKTOR AUDIO 10 should be
ready to use. Proceed with registration chapter 3.4.

3.4 Registration

Registering the TRAKTOR AUDIO 10 is not mandatory. Nevertheless, registration is recom-
mended for support inquiries or in case of theft. As a registered user, you will also benefit
from exclusive incentives and insider specials.
! !
To register your TRAKTOR AUDIO 10 on the Native Instruments website, you will need
the serial number from the product activation sticker. This is located on the bottom
panel of your TRAKTOR AUDIO 10.
To register your TRAKTOR AUDIO 10, visit our registration page on: http://www.native-
instruments.com/registration
Proceed with chapter 4.
20 – TRAKTOR AUDIO 10 – Manual
"Your devices are ready to
and follow the on-screen instructions.
found" message. Subsequently, another mes-
use" will notify you that the device driver installation
if Win-
Anyway.