Native Instruments TRAKTOR AUDIO 10 Manual page 62

6. Make sure your selected ports on the TA10 are set to LINE (so the PHONO LED does
not light on the top panel), and THRU mode is deactivated (see soundcard's top panel
LEDs). For configuring the ports, use the Control Panel software which was installed
during the software installation process in chapter 3.2. For instructions on how to open
the Control Panel and configure the ports, please read chapter 6.1.2 / 6.2.1.
7.
Connect your headphones to the headphone output of your mixer.
TRAKTOR AUDIO 10 – Manual – 61