Advanced Configuration; Advanced Configuration On Windows® (Control Panel) - Native Instruments TRAKTOR AUDIO 10 Manual

6 Advanced Configuration
On Windows®
All advanced configuration settings on Windows® can be accessed from the Control Panel
software, which was installed on your computer during the software installation proce-
dure in chapter 2. You should open the Control Panel once you have installed the drivers,
connected the hardware to your computer, and set up the interface as your default audio
output device (see chapter 4). In this chapter, you will learn about the Control Panel and
what you can do with it. Proceed with chapter 6.1.
If you experience problems with your setup, please refer to the Audio Troubleshooting
% !
Guide, which you can access from the Information section of the Control Panel's Diagnostics
page, or open it directly from the software's documentation folder.
On Mac OS® X
On Mac OS® X, there are separate dialogs for configuring the TRAKTOR AUDIO 10 port
settings and for configuring the audio and MIDI settings:
• The port configuration takes place in the Control Panel software (Applications > Native
Instruments > TRAKTOR AUDIO 10 Driver > TRAKTOR AUDIO 10 Control Panel), which
was installed on your computer during the software installation procedure in chapter 2.
• The advanced audio and MIDI settings are accessed from the Mac OS® X Audio MIDI
Setup, located in the Applications > Utilities folder. Open the Audio MIDI Setup once
you have connected the hardware to your computer, installed the drivers (chapter 2),
and set up the interface as your default audio device (see chapter 4).
Proceed with chapter 6.2.
If you experience problems with your setup, please refer to the Audio Troubleshooting
% !
Guide, which you can access directly from the software's documentation folder.
6.1 Advanced Configuration on Windows® (Control Panel)
The Control Panel software allows you to configure the port settings, change the driver's
performance settings, monitor performance, and detect errors. To open the Control Panel:
▶
Navigate to Start > All Programs > Native Instruments > TRAKTOR AUDIO 10 Driver >
Control Panel.
! !
If you cannot find the Control Panel, the software is most likely not installed. In this
case, please (re-)install the software as described in chapter 2.
On the left-hand side of the Control Panel, you find three tabs: Audio
and Diagnostics:
▶
Click on the tabs to open the corresponding page of the Control Panel.
Proceed to chapters 6.1.1, 6.1.2, and 6.1.3 for more information on the Control Panel's pages.
28 – TRAKTOR AUDIO 10 – Manual
Settings, Channel Setup,