Native Instruments TRAKTOR AUDIO 10 Manual page 44

4. Attach the ground wire of your turntable to the ground post of your mixer (alternatively,
you can attach it to the ground post on the rear panel of the TA10).
5. Make sure the selected port on the TA10 is set to PHONO and THRU (see soundcard's
top panel LEDs). The port configuration takes place in the Control Panel software with
the TA10 connected to your computer. For more information on how to configure the
ports, please read chapter 6.1.2 / 6.2.1.
6. Start the playback of a record on your turntable.
7. Gradually raise the volume of the selected mixer channel until you reach a good listening level.
TRAKTOR AUDIO 10 – Manual – 43