Maximum Configuration Per Potential Group - Siemens SIMATIC ET 200S Manual

Configuration Options
• Power modules: Maximum configuration per potential group
Table 3-13 Maximum configuration per potential group
Power modules
Power module
PM-E 24 VDC
Power module
PM-E 24–48 VDC
Power module PM-E
24–48 VDC/
24–230 VAC
• Number of identifiers: one module per identifier (maximum 63 identifiers)
• You can use the ET 200S with DP masters with a diagnostic frame length of
32 bytes because you can set the length of the diagnostic frame in all the
interface modules (see Sections 6.6.2 and 9.1).
3-42
Maximum
current-carrying
capacity
10 A The number of modules that can be
connected depends on the total current of
all the modules in this potential group.
This must not exceed 10 A in total. The
total current is decisively affected by the
digital output modules: digital output modules:
10 A
•
•
•
•
•
10 A (24 VDC)
8 A (120/230 VAC)
•
•
•
•
Connectable modules
2DO 24 VDC/0.5 A Standard
2DO 24 VDC/0.5 A High Feature
4DO 24 VDC/0.5 A Standard
4DO 24 VDC/0.5 A High Feature 4DO 24 VDC/0.5 A High Feature
2DO 24 VDC/2 A Standard
2DO 24 VDC/2 A High Feature
4DO 24 VDC/2 A Standard
4DO 24 VDC/2 A High Feature
2DO 24–230 VAC/2 A
ET 200S Distributed I/O System
EWA-4NEB780602402-09