Siemens SIMATIC ET 200S Manual page 136

Commissioning and Diagnostics
6.1 Configuring the ET 200S
Introduction
This chapter describes how to configure and assign parameters to the ET 200S.
• Configuration: The systematic arrangement of the different ET 200S modules
(setup)
• Parameter assignment: Setting the ET 200S parameters using the configuration
software
Note
The ET 200S is included in the hardware catalog of HWCONFIG:
IM151-1 BASIC: as of STEP 7 V5.2
•
IM151-1 STANDARD: as of STEP 7 V5.0 with ServicePack 3
•
IM151-1 FO STANDARD: as of STEP 7 V5.1 with ServicePack 1
•
IM151-1 HIGH FEATURE: as of STEP 7 V5.1 with ServicePack 3
•
You will not need a device database file (*.GSD file). Advantages:
Simplified grouping of the modules (by means of the "Pack Addresses" button
•
in HWCONFIG)
Plausibility checking of the parameters
•
The STEP 7 online help provides more detailed information on how to proceed.
STEP 7
• STEP 7 does not support the reading back of the configuration
(PLC
• It is not possible to read out the ET 200S diagnosis via the CPU 315-2 DP (with
the "Diagnosing Hardware" function in STEP 7) until order no. 6ES7315-2AF02.
6-2
Upload).
"
ET 200S Distributed I/O System
EWA-4NEB780602402-09