5.8
Installing the server module
Introduction
The server module on the far right of the assembly/line completes the ET 200SP distributed
I/O system.
Requirement
The last BaseUnit is mounted.
Installing the server module
Watch "Install configuration" video sequence
(http://support.automation.siemens.com/WW/view/en/95886218)
Proceed as follows to install a server module:
1. Hook the server module onto the mounting rail to the right of the last BaseUnit.
2. Swivel the server module backwards on the mounting rail.
3. Move the server module parallel to the left until you hear it latch onto the last BaseUnit
that precedes it.
Figure 5-6
Removing the server module
Proceed as follows to remove a server module:
1. Press the mounting rail release button on the server module.
2. Move the server module parallel to the right.
3. While pressing the mounting rail release button, swivel the server module off the
mounting rail.
Distributed I/O system
System Manual, 09/2019, A5E03576849-AJ
Installing the server module
Installation
5.8 Installing the server module
79