Table of Contents
Advertisement
Installation
3
Figure 5-4 Installing the Terminal Module TM-PS
Uninstalling Terminal Module TM-PS
The terminal module is wired up and there are further terminal modules to the right
of it.
1. Turn off the power supply on the terminal module TM-PS.
2. Open the hinged cover on the screw terminal and release the wiring on the
terminal module TM-PS with the screwdriver.
3. Release the mechanical securing mechanism of the terminal module: Orange
signal color in the opening below the securing screw.
4. Using the screwdriver press down the slider on the terminal module TM-PS as
far as it will go and shift the terminal module to the left.
Note: The slider is located below the terminal module. See figure above.
5. Holding down the slider, pull the bottom of the terminal module away from the
DIN rail.
5-6
Slider
1
2
ET 200iS Distributed I/O Station
A5E00087831-02
Advertisement
Table of Contents
