Siemens SIMATIC ET 200S Manual page 509

Table 14-4 Enhanced control interface
Address
Byte 2
Byte 3
ET 200S Distributed I/O System
EWA-4NEB780602402-09
Assignment
Specify sensitivity/distance value on
channel 2 channel 2
•
Bit 0: Bit 0:
1: Transfer sensitivity/distance value to the
sensor on channel 2 sensor on channel 2
(using rising edge)
0 D 0: Deactivated ti t d
• •
Bit 1 to bit 7: Bit 1 to bit 7:
Sensitivity/distance value
on channel 2: 1 to 126 (depending on the on channel 2: 1 to 126 (depending on the
sensor)
Teach-in on channel 2
•
Bit 0:
1: Start teach-in on the sensor on channel 2
(at the rising edge)
0: Deactivated
•
Bit 1 to bit 7: 0
Specify sensitivity/distance value on
channel 3 channel 3
• Bit 0: Bit 0:
1: Transfer sensitivity/distance value to the
sensor on channel 3 sensor on channel 3
(using rising edge)
0: Deactivated 0 D ti t d
• • Bit 1 to bit 7: Bit 1 to bit 7:
Sensitivity/distance value
on channel 3: 1 to 126 (depending on the on channel 3: 1 to 126 (depending on the
sensor)
Teach-in on the sensor on channel 3
•
Bit 0:
1: Start teach-in on the sensor on channel 3
(at the rising edge)
0: Deactivated
•
Bit 1 to bit 7: 0
4 IQ-SENSE
Designation on
"IQ-SENSE Opto" FB
WR_TEACH_VAL
TEACH_VAL_IN
START_TEACH
WR_TEACH_VAL WR TEACH VAL
TEACH_VAL_IN
START_TEACH
14-13