Setting Snmp Parameters - Huawei NetCol5000-C Series User Manual

NetCol5000-C030 In-row Chilled Water Smart Cooling
Product
User Manual (Simple Configuration)
Parameter
Client
encryption
Server
encryption
EMS IP
address
EMS port
----End

4.3.2.6 Setting SNMP Parameters

Context




Procedure
Step 1 On the home screen, choose Settings > Comm Settings > SNMP Settings.
displayed.
Issue 09 (2020-01-10)
Setting
Enable, Disable
Enable, Disable
N/A
N/A
To set communications parameters, log in as the Admin, Engineer, or Operator user.
This section is suitable only for SNMP. Skip this section if you use Modbus.
Record the values entered in this section. They will be used when you access a smart
cooling product to a NMS (network management system).
One smart cooling product supports concurrent access of up to 10 NMSs through SNMP.
Copyright © Huawei Technologies Co., Ltd.
Setting Method
cooling product, as a client, can connect to a
remote server and establish communication.

If you set Connection mode to Server+client,
the smart cooling product, as a server, supports
one client connection and establishes
communication. In addition, the smart cooling
product, as a client, can connect to a remote
server and establish communication.
The default value is Enable. This parameter is
configurable when Connection mode is set to
Client.
The default value is Disable. This parameter is
configurable when Connection mode is set to
Server.
Enter the actual IP address of the EMS. IP addresses
of the display panel, EMS client, and EMS server
must be unique. This parameter is configurable when
Connection mode is set to Client.
It is recommended that you retain the default value
16100. If you need to change the value, enter a value
as required. This parameter is configurable when
Connection mode is set to Client.
4 ACC Introduction
Figure 4-9 is
88