Commissioning Smart Cooling Product Components - Huawei NetCol5000-C Series User Manual

NetCol5000-C030 In-row Chilled Water Smart Cooling
Product
User Manual (Simple Configuration)
----End

4.3.3.2 Commissioning Smart Cooling Product Components

Context
For safe system operation, when smart cooling product components are started, the following
coupling relationships are presented:





Procedure
Step 1 Enter diagnostic mode.
Step 2 Tap On for Electric heater, as shown in
Figure 4-22 Starting up the electric heater
After the electric heater is started, the Off following the Electric heater turns into On.
----End
Issue 09 (2020-01-10)
 To exit the diagnostic mode, tap
 The system automatically exits diagnostic mode when it reaches the maximum diagnostic mode
duration.
When the electric heater is started, the corresponding indoor fan automatically starts.
When the electrode humidifier is started, the corresponding indoor fan automatically
starts.
If you need to manually turn on or off system components in diagnostic mode, log in as
the Admin or Engineer user. Ensure that the smart cooling product is started before
operation.
For details about the parameters and specifications to be set, see the commissioning
chapter in the user manual of each smart cooling product.
This chapter describes how to commission smart cooling product components, using the
electric heater as an example.
Copyright © Huawei Technologies Co., Ltd.
on the status bar.
Figure 4-22.
4 ACC Introduction
104