Inspire M4 Assembly & Operation Manual page 37

STEP 59
Floating Pulley
Bracket
Floating Pulley Stop
STEP 60
NOTE: At this point it is necessary to seat the cables. Start by verifying that cables are
centered in the grooves of all pulleys. Next, select a weight you can
comfortably handle on the bench press. Perform a seated bench press and hold
the first repetition at arms length. Now, lightly bounce the weight up and down
for about 5 seconds. This will seat the cables into the pulleys and prepare the
gym for Step 58.
Step 58: Eliminate cable slack by adjusting Press Arm Bumper counter clockwise.
Wrench Tighten Jam Nut.
Step 59: Adjust Floating Pulley Stop until bottom surface contacts Floating Pulley
Bracket then Wrench Tighten Jam Nut.
Step 60: Adjust the cable bolt to 1" between the top of the bolt and the bracket on the
Main Base and Wrench Tighten Jam Nuts.
Cable Bolt
Page 34
STEP 58
Press Arm Bumper