Inspire M4 Assembly & Operation Manual page 27

Cable Retainer
Pulley 7
Pulley 8
Pulley 9
Step 41: Continue routing Upper Cable around Pulleys 7 ,8,9 and Pulley 10 towards front
of machine to Pulley 11 as shown in diagram.
Step 42: Assemble Cable End by sliding one plastic ball onto the end of the cable. Next, slide
the cable end into the side of the "U" Bracket. Finally, attach a spring clip to the "U"
Bracket using a 5/16" x 1 ¼" Shoulder Bolt and 5/16" Lock Nut.
One (5/6" x 1 ¼" Shoulder Bolt)
One (Plastic Ball)
(Make sure that the cable is routed between pulley 11 and cable retainer)
STEP 42
1 – Plastic Ball
1 – "U" Bracket
1 – 5/16" x 1 ¼" Shoulder Bolt
1 – Spring Clip
1 – 5/16" Lock Nut
Pulley 11
One ("U" Bracket)
(Wrench Tighten Bolt)
Page 24
"U" Bracket
NOTE: Once Assembled,
Slide rubber washer against
plastic ball.
Spring Clip
STEP 41
Upper Cable
Pulley 6
Pulley 10
One (5/16" Lock Nut)
One (Spring Clip)