Inspire M4 Assembly & Operation Manual page 33

STEP 49
Guide Pulleys
STEP 51
2 – 3/8" x 2 ½" Hex Bolts
4 – 3/8" Small OD Washers
2 – 3/8" Thin Lock Nuts
Cable End
w/ Bushing
Step 49: Attach Leg Extension Cable Bolt to bracket on the Main Base, hand feed thru hole
from bottom, install Jam Nuts on top and bottom side of bracket as shown using:
Step 50: Route cable around Pulley 1 (Dual Floating Pulley), route between cable retainer
and Pulley 2 , thru guide pulleys, route between cable retainer and Pulley 3.
Step 51: Attach Cable by sliding end of cable thru slot of cable end, then slide Bushing
into cable end, attach to Leg Extension Arm with Hex Bolts and small OD Washers
on each side of Bushing as shown using:
(Wrench Tighten Bolts, Do Not Over Tighten, Assembly Should Move Freely.)
Step 52: Attach Leg Extension Cable on other side in the same way.
(Wrench Tighten Bolts, Do Not Over Tighten, Assembly Should Move Freely.)
Pulley 2
Jam Nuts
Cable Bolt
Press Arm Cable
Leg Extension Cable
Pulley 3
Cable
Page 30
STEP 50
Dual Floating Pulley
Pulley 1
Two (3/8" x 2 ½" Hex Bolts)
Four (3/8" Small OD Washers)
Two (3/8" Thin Lock Nuts)