Inspire M4 Assembly & Operation Manual page 16

Lock Nut
faces front
Pulley Yoke
Jam Nut
STEP 14
1 – 1/2" Jam Nut
Selector Stem/
Top Weight
Weight Stack
Rubber Donuts
Front of Weight Plate has recessed area
Bottom of Weight Plate has three feet
Step 13: Slide Rubber Donuts down the Guide Rods until sitting on the Shroud Plate. Next
slide each Weight Plate down the Guide Rods until all 20 Weight Plates are resting on the
Rubber Donuts. Be sure that all Weight Plates are facing forward. Front of Weight Plate is
indicated by recessed area for weight stack numbers. Next, slide Selector Stem/Top Weight
down the Guide Rods and onto Weight Stack.
Step 14: Attach Pulley Yoke to Selector Stem, verify that bolt is threaded completely into
Selector Stem with Lock Nut on Pulley facing towards front using:
(Wrench Tighten Jam Nut)
Before installing weights, adjust Bumper so it
just touches floor and tighten jam nut on both
sides of gym.
Page 13
STEP 13
Install Rubber Donuts,
Weight Stack, Selector Stem/
Top Weight (In that Order)
Guide Rods
One (1/2" Jam Nut)