Inspire M4 Assembly & Operation Manual page 18

STEP 17
1 – 2 ¾" Hex Bolt
1 – 1" Hex Bolt
3 – 3/8" Flat Washers
1 – 3/8" Lock Nut
Step 16: Attach Guide Rods to Support Beam using:
(Note: Position Guide Rods in back of Guide Rod Mount Bracket as shown)
Step 17: Attach Shroud Mount to Support Beam using:
Guide Rod
Mount Bracket
STEP 16
2 – 1 ½" Hex Bolts
4 – 3/8" Small OD Washers
2 – 3/8" Thin Lock Nuts
(Wrench Tighten Bolts)
(Wrench Tighten Bolts)
Support Beam
Shroud Mount
1" Hex Bolt
Two
Four
Two
One
One
Three (3/8" Flat Washers)
One
Page 15
Guide Rods
(3/8" x 1 ½" Hex Bolts)
(3/8" Small OD Washers)
(3/8" Thin Lock Nuts)
(3/8" x 2 ¾" Hex Bolt)
(3/8" x 1" Hex Bolt)
(3/8" Lock Nut)