Inspire M4 Assembly & Operation Manual page 32

Pulley 1
Pulley 2
Pulley 3
Step 47: Assemble cable end on Cable Column Cable by sliding one plastic ball onto the end
of the cable. Next slide the cable end into the side of the "U" Bracket. Finally, attach
attach a spring clip to the "U" Bracket using a 5/16" x 1 1/4" Shoulder Bolt and
5/16" Lock Nut.
One (5/6" x 1 ¼" Shoulder Bolt)
One (Plastic Ball)
Step 48: Begin by routing Cable Column Cable around Pulleys 1, 2, 3 and 4, around Floating
Pulley Bracket, around Pulleys 5, 6 and 7, then around Pulley 8 as shown . Finally
attach cable end as shown in step 47 diagram.
Pulley 6
Pulley 7
Cable Column Cable
Pulley 8
Floating Pulley Bracket
Pulley 5
One ("U" Bracket)
Page 29
STEP 48
Pulley 4
"U" Bracket
Spring Clip
STEP 47
2 – Plastic Ball
2 – "U" Bracket
2 – 5/16" x 1 1/4" Shoulder Bolt
2 – Spring Clip
2 – 5/16" Lock Nut
One (5/16" Lock Nut)
One (Spring Clip)
(Wrench Tighten Bolts)
NOTE: Once Assembled,
slide rubber washer against
plastic ball.