Inspire M4 Assembly & Operation Manual page 26

STEP 38
Upper Cable
Pulley 6
Step 38: Begin by routing Upper Cable from back of machine around Pulley 2 towards front
of machine to Pulley 1 as shown in diagram.
Step 39: Assemble Cable End by sliding one plastic ball onto the end of the cable. Next, slide
the cable end into the side of the "U" Bracket. Finally, attach a spring clip to the "U"
Bracket using a 5/16" x 1 ¼" Shoulder Bolt and 5/16" Lock Nut.
One (5/6" x 1 ¼" Shoulder Bolt)
One (Plastic Ball)
(Make sure that the cable is routed between pulley 1 and cable retainer)
Step 40: Continue routing Upper Cable around Pulleys 3, 4 5 and 6 as shown.
STEP 39
1 – Plastic Ball
1 – "U" Bracket
1 – 5/16" x 1 ¼" Shoulder Bolt
1 – Spring Clip
1 – 5/16" Lock Nut
Pulley 2
Pulley 3
Pulley 4
Pulley 5
STEP 40
One ("U" Bracket)
(Wrench Tighten Bolt)
(Cable Routing Steps continued on next page)
Page 23
"U" Bracket
Spring Clip
Pulley 1
One (5/16" Lock Nut)
One (Spring Clip)
NOTE: Once Assembled,
slide rubber washer
against plastic ball.
Cable Retainer