Inspire M4 Assembly & Operation Manual page 22

Step 26: Insert Seat Mount Link thru cut-out in Seat Frame and position Link Tab as shown.
Step 27: Rotate Seat Mount Link Tab 90° clockwise around stop pin and slide
Seat Mount Link thru cut-out until hole and stop pin engage as shown.
Step 28: Insert Coil Spring onto handle pin, then attach Seat Mount to Seat Frame using:
(Wrench Tighten Bolts, Do Not Over Tighten, Assembly Should Move Freely.)
Seat Mount Link
Stop Pin
Seat Frame
Seat Mount Link
Coil Spring
Handle
Seat Frame
One
Two
One
One
Page 19
STEP 26
STEP 27
STEP 28
1 – 1/2" x 4" Hex Bolt
2 – 1/2" Flat Washers
1 – 1/2" Thin Locknut
1 – Coil Spring
(1/2" x 4" Hex Bolt)
(1/2" Flat Washers)
(1/2" Thin Locknut)
(Coil Spring)
Link Tab
Stop Pin
Link Tab