Inspire M4 Assembly & Operation Manual page 28

STEP 43b
1 – 3/8" x 2 ¼" Hex Bolt
1 – 3/8" x 2 ¼" Flat Head Bolt
3 – 3/8" Flat Washers
2 – 3/8" Lock Nuts
Hex Bolt
Flat Head Bolt
STEP 43a
1 – 3/8" x 5 ½" Hex Bolt
2 – 3/8" Small OD Washers
Step 43a: Attach Left Press Arm Cable by sliding end of cable thru slot of Cable End as
shown, then slide Bushing into Cable End, attach with Hex Bolt and small
OD Washers on each side of bushing using:
One (3/8" x 5 ½" Hex Bolt)
Step 43b: Route the Press Arm Cable as Pulley 1 is attached to Press Arm Mount, route
cable around Pulley 2, route cable as Pulley 3 is attached to Press Arm Mount,
route cable around Pulley 4 using:
One (3/8" x 2 ¼" Hex Bolt)
Three (3/8" Flat Washers)
Cable End
w/ Bushing
(Wrench Tighten Bolts)
Pulley 4
Pulley 3
Pulley 2
Pulley 1
Cable
Two (3/8" Small OD Washers)
One (3/8" x 2 ¼" Flat Head Bolt)
Two (3/8" Lock Nuts)
Page 25
Press Arm
Cable (Left)
Cable End
w/ Bushing