Inspire M4 Assembly & Operation Manual page 31

Step 46a: Continue routing cable around Pulley 4, route cable as Pulley 3 is attached to
Press Arm Mount, route cable around Pulley 2, route cable as Pulley 1 is attached
to Press Arm Mount, attach cable by sliding end of cable thru slot of Cable End,
then slide Bushing into Cable End using:
One (3/8" x 2 ¼" Hex Bolt)
Three (3/8" Flat Washers)
Step 46b: Attach Cable End with small OD Washers on each side of bushing using:
Two (3/8" small OD Washers)
(Wrench Tighten Bolts, Do Not Over Tighten, Assembly Should Move Freely.)
Press Arm
Cable (Right)
Pulley 4
Pulley 3
Pulley 2
Pulley 1
Cable
Cable End
w/ Bushing
(Wrench Tighten Bolts)
Page 28
STEP 46a
1 – 3/8" x 2 ¼" Hex Bolt
1 – 3/8" x 2 ¼" Flat Head Bolt
3 – 3/8" Flat Washers
2 – 3/8" Lock Nuts
STEP 46b
2 – 3/8" Small OD Washers
1 – 3/8" Lock Nuts
One (3/8" x 2 ¼" Flat Head Bolt)
Two (3/8" Lock Nuts)
One (3/8" Lock Nut)
Hex Bolt
Flat Head Bolt