Inspire M4 Assembly & Operation Manual page 20

NOTE: Single Tabs on
Top of Pulley Covers
Must face towards rear
STEP 20
4 – 4" Pulleys
2 – Pulley Covers
2 – 3/8" x 6" Hex Bolts
4 – 3/8" Flat Washers
2 – 3/8" Lock Nuts
NOTE:
Index Plates
Face Outwards
`
Step 20: Attach Pulleys and Pulley Covers to Main Upright using:
Four (4" Pulleys)
Two (3/8" x 6" Hex Bolts)
Two (3/8" Lock Nuts)
(Single Tabs on Top of Pulley Covers Must face towards rear)
(Wrench Tighten Bolts)
Step 21: Attach Press Arm Mounts, Left & Right to Main Upright using:
One (1/2" x 9" Hex Bolt)
One (1/2" Lock Nut)
(Note: Index Plates Face Outward)
(Wrench Tighten Bolt)
Step 22: Attach Press Arms, Left & Right to Press Arm Mounts using:
Two (1/2" Large OD Washers
(Wrench Tighten Nuts, Do Not Over Tighten, Assembly Should Move Freely.)
Step 23: Attach Foot Platforms to Main Base using:
Four (3/8" x 1 ½" Button Head Bolts)
Four (3/8" Lock Nuts)
(Use 6mm Hex Wrench to Tighten Bolts)
Page 17
STEP 21
1 – 1/2" x 9" Hex Bolt
2 – 1/2" Flat Washers
1 – 1/2" Lock Nut
STEP 22
2 – 1/2" Large OD Washers
2 – 1/2" Thin Lock Nuts
STEP 23
4 – 3/8" x 1 ½" Button Head Bolts
8 – 3/8" Flat Washers
4 – 3/8" Lock Nuts
Two (Pulley Covers)
Four (3/8" Flat Washers)
Two (1/2" Flat Washers)
Two (1/2" Thin Lock Nuts)
Eight (3/8" Flat Washers)
Press Arm Mounts
Press Arms
Foot Platform