Show Ip - GE PACSystems RX3i Command Line Interface Manual

`

show ip

show ip
Global Command
This command displays Internet Protocol (IP) status and counters.
show ip Command Format
show ip [conn | counters | status]
Examples
Displaying all IP Details
device-name> show ip
01-JAN-2000 00:44:37.0000
Network Stack Version: v4/v6 Host (v4 only build) stack ver. 3.1.2.0
<<< IP Status >>>
Ip:
1846 total packets received
0 forwarded
0 incoming packets delivered
1576 incoming packets delivered
724 requests sent out
1 dropped because of missing route
Icmp:
1 ICMP message received
0 input ICMP message failed
ICMP input histogram:
destination unreachable: 1
1 ICMP messages sent
0 ICMP messaged failed
ICMP output histogram:
destination unreachable: 1
INET route table – vr: 0, table: 254
Destination
-------------------------------------------------------------------------
10.10.0.0
224.0.0.0
-------------------------------------------------------------------------
INET sockets
Proto Recv-Q Send-Q
----- ------ ------
TCP 0
TCP 0
GFK-2572
Screen Display
Gateway
10.10.0.2
10.10.0.2
Local Address
--------------------- ---------------- ----
0 10.10.0.100.23
0 0.0.0.0.23
Chapter 2 Monitor Level Commands
Flags Use IF
UGS 0 gei0
UC 2 gei0
Foreign Address
10.10.0.1.4066
0.0.0.0.0
2
Metric
0
0
State
ESTABLISHED
LISTEN
2-31