Telnetd - GE PACSystems RX3i Command Line Interface Manual

3

telnetd

Non-Global Command
This command enables or disables the telnet server. To take effect, change in telnet server
status requires a power cycle or restart . telnet is disabled by default, and is enabled by
accessing the Command Line Interface by connecting directly to the Controller via the
Micro USB port. This parameter is preserved over a power cycle.
telnetd Command Format
[no] telnetd [<maxConnections>]
< maxConnections > The maximum number of telnet connections allowed. Valid values are 1
Examples
Enabling Telnet
Step1. Use telnetd to enable the Telnet server.
device-name= telnetd
Enabling telnet Server
telnet changes will not take effect until next powerup or restart
device-name=
Step 2. Restart or power cycle the PNC. Use show telnet to display the Telnet status.
{Power-cycle occurs}
device-name> show telnet
01-JAN-2000 05:44:17.0000
<<< Telnet Info >>>
telnet Status:
Max telnet Connections:
Active telnet Connections:
device-name>
PACSystems* RX3i PROFINET Controller Command Line Interface Manual – July 2011
3-20
through 16 inclusive. The default is 2.
Screen Display
Screen Display
Enabled
16
1
telnetd
GFK-2572