GE PACSystems RX3i Command Line Interface Manual page 16

1
Modify Level Commands
The following commands are additionally available in Modify level.
Command
arp [add |clear ]
blinkId [begin | end]
clear arp
clear counters [all |
icmp | igmp | ip |
network |rdnMedia |
tcp | udp]
clear log
clear statLED
default
loginCfg [password |
default ]
logout
[no] monport
[<monitor> < <ports>]
Ping <ip>
restart
sessionTimeout
[<seconds>]
[no] telnetd
Time <date> <time>
PACSystems* RX3i PROFINET Controller Command Line Interface Manual – July 2011
1-10
Non-Global. clear clears ARP cache.
add adds a static entry in ARP table.
Non-Global. Begin/End blinking Identification LED pattern. blinkId with no
parameters displays whether the pattern is Blinking or Stopped.
Non-Global. Clears ARP cache. (Equivalent to arp clear.)
Non-Global. Clear specified counters or clear all counters.
clear counters does not clear all counters. Enter clear counters all to clear all
counters.
Non-Global. Clears the local log table and resets the counter of lost log entries.
Non-Global. Reset the STATUS LED (log isn't cleared). The STATUS LED is
turned on until the next entry is placed into the local log table. This command
does nothing if the module has an invalid MAC Address (STATUS LED Red
and blinking).
Non-Global. Returns module to factory default values and logs out of Modify
Access level. Does not affect MAC addresses.
Non-Global. Change the login password. loginCfg default returns login
password to the default. The password setting persists over a power cycle.
Non-Global. Return to Monitor Access Level.
Non-Global. Display the monitor port and the ports being monitored. Port
monitoring is enabled by specifying the optional monitor port and one or more
ports to be monitored.
no monport disables port monitoring.
Non-Global. Sends ICMP Echo requests.
Non-Global. Restarts the module firmware and logs out of Modify Access level.
Non-Global. Displays and sets the session inactivity timeout value.
Non-Global. telnetd enables the telnet server. no telnetd command disables
the telnet server. This requires a power cycle to take effect. telnet is disabled
by default. This parameter is preserved over a power cycle.
Non-Global. Changes the internal IO LAN clock.
Description
GFK-2572