GE PACSystems RX3i Command Line Interface Manual page 23

`
help
Displaying Parameters for a Command
This example shows the use of ? to display the parameters for the Show command..
device-name> show ?
arp
config
icmp
ip
log
mac
mem
network
node
port
profinet
rdnMedia
sessionTimeout
sm
tcp
telnetd
time
udp
device-name>
GFK-2572
Screen Display
- Show ARP table
- Show Configuration items
- Show ICMP status and/or counters
- Show IP status and/or counters
- Show local log table
- Show active and non-volatile MAC addresses
- Show System Memory status and/or counters
- Show Network Interface status and/or counters
- Show Identification, Status and Module Info
- Show Ethernet port info
- Show PROFINET status and/or counters
- Show Media redundancy status and/or counters
- Show session inactivity timeout value
- Show shared memory status and/or counter
- Show TCP server status and/or counters
- Show whether telnet is enabled or disabled
- Show internal module clock
- Show UDP status and/or counters
Chapter 2 Monitor Level Commands
2
2-7