GE PACSystems RX3i Command Line Interface Manual page 13

Monitor Level Commands
Command
Alias [replacement text]
[command name]]
cls
help [global | edit], ?
history [clear]
!<history Number>

up arrow ( ) or <ctrl>p

down arrow ( ) or
<ctrl>n
log [details [<entry>]]
login
node
shConfig
show arp
show config
[deviceName | ip |
rdnMedia | all]
GFK-2572
Global. Used to assign a different name to a string. For example entering
alias sh show would set up the alias sh for show that may be used in
subsequent commands, for example sh time for the show time command.
Alias definitions are not saved between sessions. Enter alias to view the
currently-defined aliases. The module is provided with a set of default alias
for commonly-used commands
Global. Clears the current screen so that only a single command prompt is
shown at the top of screen.
Global. Displays commands available in the current access level/mode.
help global displays global commands. help edit describes key sequences
for line editing.
? or <TAB> also performs self completion or suggests possible commands
when a command is only partially entered. In addition, ? lists possible
parameters and associated help strings after a command has been fully-
entered.
Global. Shows command history with a history number associated with
each previously-entered command; clear parameter clears the command
history.
Global. Executes a command associated with the history number in the
command history.
Global. Shows previous command in command history.
Global. Shows next command in command history. Only valid after moving
up through command history with the up arrow () or <ctrl>p.
Global. Displays the local log table. This includes displaying the counter
that indicates the number of entries that were lost due to overflow. The
local log table is displayed with additional fault details by specifying the
optional details parameter. An individual log entry in complete detail by
specifying log details followed by the log entry number. This command is
equivalent to show log.
Non-Global. Enter Modify access level.
Global. Displays same information as show node command.
Non-Global. Sets and shows shell terminal configuration such as number or
rows/columns to display whether to wrap at screen width. The default
row/columns are 25/80 (equivalent to HyperTerminal defaults). shConfig
definitions do not persist between sessions.
Global. Shows ARP table.
Global. show config or show config all displays Device Name, IP
parameters (IP Address, subnet mask, gateway), redundant media role
(disabled, client, manager), ring port assignment, ring test interval, and ring
monitor count). Display individual parameter values by typing in the
parameter name. For example, show config deviceName displays only the
PROFINET Device Name.
Chapter 1 Introduction
Description
1
1-7