X500/X501 Drive-Cliq Interfaces; X514 Power Supply For Digital Outputs And Sensors - Siemens SINAMICS S120 Combi Equipment Manual

Additional system components
9.1 Terminal Module TM54F
9.1.3.2

X500/X501 DRIVE-CLiQ interfaces

Table 9- 2
The blanking covers for the DRIVE-CLiQ interfaces are included in the scope of delivery.
Blanking covers (50 x) Article number: 6SL3066-4CA00-0AA0
9.1.3.3

X514 power supply for digital outputs and sensors

Table 9- 3 Terminals for the power supply X514
Terminal
+
+
M1
M1
Including the current consumption for the digital outputs and to supply the sensor
1)
The maximum cable length that can be connected is 10 m.
Note
The two "+" and "M1" terminals are jumpered in the connector. This ensures that the supply
voltage is looped through.
206
X500/X501: DRIVE-CLiQ interfaces
Pin Signal name
1 TXP
2 TXN
3 RXP
4 Reserved, do not use
5 Reserved, do not use
6 RXN
7 Reserved, do not use
8 Reserved, do not use
A + (24 V)
B M (0 V)
Designation
Power supply
Power supply
Electronics ground
Electronics ground
Technical data
Transmit data +
Transmit data -
Receive data +
Receive data -
Power supply
Electronics ground
Technical data
Voltage: 24 V DC (20.4 ... 28.8 V)
Current consumption: max. 4 A
Max. current via jumper in connector: 20 A (15 A ac-
cording to UL/CSA)
Type: Screw terminal 3 (Page 307)
Max. connectable cross-section: 2.5 mm²
Tightening torque: 0.4 ... 0.5 Nm
Manual, (GH9), 07/2016, 6SL3097-4AV00-0BP5
1)
SINAMICS S120 Combi