Siemens SINAMICS S120 Combi Equipment Manual page 133

Table 5- 5 Assigning the DRIVE-CLiQ interfaces at the DMx20 to assign a direct measuring system to the feed axes.
DRIVE-CLiQ interface
X500
X501
X502
X503
X504
X505
Only then, if a TM54F is not used
1)
SINAMICS S120 Combi
Manual, (GH9), 07/2016, 6SL3097-4AV00-0BP5
Feed axis
X501 of the TM54F
X102 of the PPU
1)
X100 ... X103 of the NCU
Feedrate 1 at the S120 Combi
Feedrate 2 at the S120 Combi
Feedrate 3 at the S120 Combi (4 axes Power Modules)
Feedrate 1st expansion axis at the Motor Module
Feedrate 2nd expansion axis at the Motor Module
Topology rules for DRIVE-CLiQ
133