Panel Mounting; Pom Mounting (Panel Mounting) - Siemens SIPLUS HCS Series Operating Instructions Manual

5.10.2

Panel mounting

5.10.2.1

POM mounting (panel mounting)

Installing the Power Output Modul (POM)
1. Predrill the holes in the rear panel for mounting.
The required hole spacing is shown in the diagram below.
2. Screw the POM into place on the rear panel with four screws M5.
Figure 5-12
Minimum spacing
Natural convection must be possible above and below the device. A clearance of 100 mm
must be observed in both cases.
SIPLUS HCS4200 PROFINET/PROFIBUS DP
Operating Instructions, 07/2019, A5E35066204A/006
POM4320: Position of the mounting holes
5.10 Mounting a POM4320 power output module
Installation/mounting
67