Siemens SIPLUS HCS Series Operating Instructions Manual page 191

Position of fuses on the board
Figure 12-1
Checking and changing fuses
Note
Electronic components are fitted to the rear of the board. When replacing fuses, ensure that
these components are not damaged.
1. Check for ruptured or defective fuses (refer to fault information in the section
"Diagnostics data")
2. Remove the defective fuse with a suitable tool (e.g. flat-nose pliers) and insert the new
fuse in the fuse holder.
SIPLUS HCS4200 PROFINET/PROFIBUS DP
Operating Instructions, 07/2019, A5E35066204A/006
Position of fuses on the board
Service and maintenance
12.3 Fuse replacement
189