Installing The Central Interface Module (Cim) - Siemens SIPLUS HCS Series Operating Instructions Manual

5.4

Installing the central interface module (CIM)

Tool
You will need a Torx T10 screwdriver.
Installing a central interface module
The Central Interface Module is screwed directly to the rack. The mounting steps are
described below:
Figure 5-5
Steps
1
2
3
SIPLUS HCS4200 PROFINET/PROFIBUS DP
Operating Instructions, 07/2019, A5E35066204A/006
Mounting the CIM
The fixing screws are screwed into the CIM in the delivery condition.
Loosen the six fixing screws.
Connect the connector of the system interface to the CIM
Place the CIM on the rack
5.4 Installing the central interface module (CIM)
②
and fasten it with the 6 screws
Installation/mounting
①
③
.
57