Table of Contents
Advertisement
Installing/mounting
5.2 Installing the Power Output Module (POM)
5.2.2
Panel mounting
5.2.2.1
POM mounting (panel mounting)
Installing the Power Output Modul (POM)
1. Predrill the holes in the rear panel for mounting.
The required hole spacing is shown in the diagram below.
2. Screw the POM into place on the rear panel with four screws M5.
Figure 5-2
Minimum spacing
Natural convection must be possible above and below the device. A clearance of 100 mm
must be observed in both cases.
48
POM4320: Position of the mounting holes
SIPLUS HCS4300 PROFINET/PROFIBUS DP
Operating Instructions, 10/2019, A5E35452705A/005
Advertisement
Table of Contents
