Installing The I/O Module (Pm) - Siemens SIPLUS HCS Series Operating Instructions Manual

Installation/mounting

5.5 Installing the I/O module (PM)

5.5 Installing the I/O module (PM)
The CIM is equipped with a receptacle for one I/O module.
Note
The I/O module may only be inserted or removed when the power is off.
Tool
You will need a Torx T8 screwdriver.
Installing an I/O module
The steps for mounting an I/O module are described below:
Figure 5-6
Steps
1
2
3
58
Installing an I/O module
Dismantling the blanking cover of the receptacle on the CIM
Insert the I/O module into the receptacle and push it in as far as it will go.
Secure module tightly with screws
①
SIPLUS HCS4200 PROFINET/PROFIBUS DP
Operating Instructions, 07/2019, A5E35066204A/006