Rear Panel Connections
The following connections are available on the rear panel. To setup the remote
interfaces, refer to
No.
1
2
3
4
5
6
7
Keysight N1913/1914A Installation Guide
"Remote Interface Configurations"
1
7
6
Connections
VGA Output (Option 010)
Ground Connector
USB Type A port (Option 008, Option 009)
This USB port is solely for U2000 Series power sensors usage only.
Recorder 1/2
Recorder output (two outputs are fitted to dual channel meters) connections are made via BNC
connectors. This output produces a DC voltage that corresponds to the power level of the
channel input.
AC Inlet
This power meter has an auto configuring power supply. This allows it to operate over a range of
voltages without manually being set to a certain voltage.
Trig In/Trig Out
Trigger input and output connections are made via BNC connectors.
USB Mini-B port
This USB port is used for remote interface connection.
2
3
4
8
9
Getting Started
on page 39.
5
1
37