Table of Contents
Advertisement
Check result 6
Check result 7
9) Analog output (Only available when DAC output unit is mounted)
10) BCD Output (Only available when BCD output unit is mounted.)
・Check result 6
When +SIG terminal and -SIG terminal are connected,
「SENSOR」is checked.
Two check result screens 6 and 7 are available for this
SENSOR test.
Red : short, Yellow : open
Check result screen 6 represents that 「R1」 and 「R4」 short,
and「R2」and「R3」open.
Or it represents that one of「R1」,「R2」,「R3」, and「R4」
is in this state.
・Check result 7
Check result screen 7 represents that「R1」and「R4」open,
and「R2」and「R3」short.
Or it represents that one of「R1」,「R2」,「R3」, and「R4」
is in this state.
*Caution :「SENSOR」check function cannot check other
troubles than the above-mentioned accurately. Therefore, it
is recommendable to remove the sensor itself and then
check it.
・Pressing "0%", "50%", or "100%" key
outputs voltage or current from the
terminal of the selected type
・Pressing "▲" key returns to 「Itemized
setting screen 4/4」.
・Pressing "MENU" key returns to the
normal display screen.
corresponding to the indicated value.
・Enter a numerical value to be output
to the BCD output terminal with a
numerical value and "Polarity" key.
data (BCD code) is output to the BCD
output terminal.
that digit.
・Pressing "▲" key returns to 「Itemized
setting screen 4/4」.
・Pressing "MENU" key returns to the
measurement screen.
BCD output becomes an output
corresponding to the indicated value.
・An input of 99999 or -99999 will
output and over signal.
Key
±10V type
0%
-10V
50%
0V
100%
10V
Analog output becomes an output
Press "SET" key, and the set numeric
Up to 5 digit-figures can be set.
When no digit is set, "0" is output for
77/118
4 to 20mA type
4mA
12mA
20mA
Advertisement
Table of Contents
