Table of Contents
Advertisement
Acquisition completion screen
cursor key
10) Outlying waveform reading (Rejection Data Read)
・When analog input value is outside the HI/LO limit set value or HI/LO
limit waveform set value, such waveform is read.
・Select a waveform to be read.
Up to 4 waveforms can be stored in memory by automatic updating.
(No backup is available.)
・If「6. Basic Function Setting (Setup) 1) Meter Setting」is changed or
the pattern is changed at the pattern select terminal, RS-232C or
RS-485, All the memorized waveforms outside the range are cleared.
(1) 1 Times Before
(2) 2 Times Before
(3) 3 Times Before
(4) 4 Times Before
(5) Rejection Data Store
・"Rejection Data Store" key is usually turned on for automatic
updating. Each time it is pressed, "ON/OFF" is alternately switched.
(No backup is available.)
・When there is a waveform to be kept during automatic updating, turn
it off.
・When (1) "1 Times Before" key is pressed, the last outlying waveform
is displayed.
・When reading on the cursor point, reading in accordance with the
same procedure as the above-mentioned「9) Wave Data Read」is
possible.
11) Outlying waveform clearing (Rejection Data Clear)
・Each time "Rejection Data Clear" key is pressed, the outlying
waveform is cleared in chronological order.
Each point display screen
・The displacement set value of
X-axis is not available at the
time of hold and waveform
comparison.
Last outlying screen
71/118
Advertisement
Table of Contents
