Table of Contents
Advertisement
●Comparison function
Setting range : ±99999
Hysteresis : ±0 to 9999 (Not used in comparison output type "Area".)
Type of comparison output : Select from among Normal, Area and Rank.
Comparison output : 5kinds (HH, HI, GO, LO, LL)
Photo-coupler output : NPN open collector output (including Waveform Comparison / Waveform &
●Waveform comparison function
Set HI/LO limit set value of 2048 points per pattern (up to 8 patterns can be set). After starting, this
function serves to check whether indicated value is within HI/LO limit set value or not for comparison
in real time and outputs results.
・Waveform Comparison (X-axis = time)
Comparison output = Y-axis HI, GO, LO
・Waveform & Displacement Comparison (X axis = displacement)
Comparison output = Y-axis HI, GO, LO,
●SD memory function : Can write the reading and writing of setting data of meter and waveform data.
(Option)
●I/O function
RS-232C output : Various settings are available from host computer. In addition, it is possible to read
operating state.
RS-485 output : Up to 31Meters can be connected to host computer.
(Option)
BCD output : Open collector output (NPN type).
(Option)
Output capacitance Voltage MAX 30V, current MAX 15mA.
(Output cycle is based on sampling speed) (Channel to be output is selectable.)
・Output signal
・Output signal
Analog output : D/A converter used (Channel to be output is selectable.)
(Option)
Resolution Approx. 16bits
Output
±0 to 10V
4 to 20mA
Accuracy (23℃±5℃, 35 to 85％RH)
Displacement Comparison)
Output capacitance Voltage MAX.30V Current MAX.30mA
Saturation voltage MAX.1.2V
Setting value can be read out.
Target media － 32M, 64M, 128M, 256M, 512M
Maximum file number － 9999
File size － Management table
Wave data
Setting data
BCD, OVER, POL, PC
ENABLE
Load resistance
More than 10kΩ
Less than 550Ω
X-axis HI, LO (displacement output)
Approx. 20k byte
Approx. 100k byte
Approx. 200k byte
Accuracy
± (0.5% of FS)
± (0.5% of FS)
111/118
Ripple
50mVpp
25mVpp
Advertisement
Table of Contents
