Table of Contents
Advertisement
Itemized setting screen 4/5
Itemized setting screen 5/5
5) Decimal Point
・Set a decimal point position to be displayed on the set-value select
screen.
・Setting items : 0, 0.0, 0.00, 0.000, 0.0000
6) Digital Shift
・Function provided to simply shift the indicated value.
Indicated value = (Internal indicated value) + (digital shift value)
・Set it on the 10-key input screen.
・Setting range : ±99999
7) Unit
・Set the unit corresponding to the indicated value.
・Set it on the set-value select screen.
・79 different setting items (including those without display)
「Refer to 29. Setting of Units」
8) Moving Average
・This function is provided for the moving average of data after A/D
conversion so as to reduce the fluctuation of the indicated values. As the
number of times of moving average is increased, the indicated value is
stabilized. However response becomes slow.
・Set it on the set-value select screen.
・Setting items : OFF, 2, 4, 8, 16, 32, 64, 128, 256, 512, 1024 times.
9) Analog Filter
・Low pass filter provided to remove unnecessary noise components
from analog input signal. As the cut-off frequency becomes large,
response becomes quick. However, noise component may be contained.
・Set it on the set-value select screen.
・Setting items : 10, 30, 300, 600
10) Digital Limiter (HI/LO)
・Specify the display range of indicated values. When it is outside the
display range, a digital limiter value is displayed.
・Set it on the 10-key input screen.
・Setting conditions
Digital Limiter HI > Digital Limiter LO
・Setting range
Digital Limiter HI -99998 to 99999
Digital Limiter LO -99999 to 99998
11) Step
・Set the minimum updating width of indicated values.
・Set it on the set-value select screen.
・Setup items : 1, 2, 5, 10
41/118
Advertisement
Table of Contents
