Table of Contents
Advertisement
・Terminal No.14 ：Analog output Ach (AOUTA)
(Output terminal)
・Terminal No.15 ：Analog output Bch (AOUTB)
(Output terminal)
・Terminal No.16 ：Analog ground (AG)
(Common terminal) The common terminal of analog output (Ach) (terminal NO.14), analog output
・Terminal No.17 ：BUSY output (Used when SD memory card function is available.)
・Terminal No.18 to 21：Pattern selection (P0, P1 ,P2 ,P3)
(Input terminal)
・Terminal No.22 ：Graphic start (START)
(Input terminal)
・Terminal No.23 ：Graphic stop (STOP)
(Input terminal)
・Terminal No.24 ：Reset (RESET)
(Input terminal)
・Terminal No.25 ：Digital ground (DG), Connected with No.13 (DG) inside.
(Common terminal)
Analog output for monitors.
For details, refer to「3-4. 3) Analog output」.)
Analog output for monitors.
For details, refer to「3-4. 3) Analog output」.)
(Bch) (terminalNO.15).
The terminal is for changing the used pattern in strain gauge (analog input
setting), linearization setting, comparison setting, display setting, hold
function, waveform comparison/waveform & displacement comparison,
analog output and BCD output.
For details, refer to「3-4. 5) Pattern select and 6) Each input equivalent
circuits」.)
Start the reading of analog input waveform (indicated value). (ON ("0") trailing
edge is active.)
For details, refer to「4-6. Functional Description (13)」and「8. Operation of
Waveform Display」.
Stop the reading of analog input waveform (indicated value). (ON ("0") trailing
edge is active.)
For details, refer to「4-6, Functional Description(13)」 and「8, Operation of
Waveform Display」.
Release the hold function (use only in hold function.)
Release each peak hold with condition. (ON ("0") trailing edge is active.)
For details, refer to「11-6. to 11-9,」.
Common input terminal of terminal No.18 to 24 (P0 to P3), START, STOP,
RESET.
For details, refer to「3-4. 6) Each input equivalent circuits」.)
13/118
Advertisement
Table of Contents
